Just purchased a CZ 457. Anyone know if they are the same rings as a 455? And if they are, what would you recommend for under a $100. Scope...
I decided to buy or build an annealer in the fall of 2018 to solve my issues with inconsistent neck tension in my reloads. There are very few...
Found this on a reloading group I follow on Facebook. This is the slickest way Ive seen of handling this yet. Piece is 3d printed. [ATTACH]...
Looking for a little info for 178gr ELDs. Is a 10 thou jump about right for ELDs? Heres how it measures up on my rifle: 2.253 - tight to lands...
Looks like Im going to pick up a project for a friend of mine. His rifle is a beautiful custom that was built by a local gunsmith, that normally...
Looking for some recommendations for a rear bag for bench and prone shooting with either a rest or a bipod up front. Right around $100 max, doesnt...
I know a few guys around here use SRPs of various manufacture for other pistol calibers. I have a ton of CCI 400 primers on hand and a few...
Anyone notice the bearing surface being extremely short? Like shorter than a 68 or 69? [ATTACH] Obviously not a great photo, but measuring the...
I bought a WFT2 about 3 years ago, and since then its had about 50k piece of brass trimmed on it, all of it being 308, 223 and 300 BO (creation...
Hey all Ive done a fair amount of searching on various forums for load data using Missouri Bullet Co Hi-tek coated bullets, and had a couple...
I was approached by a friend about reloading for his M1 Carbine. I told him I dont reload for anyone but myself, but if hes willing to put in the...
Separate names with a comma.
