Sorted range brass. Inventoried bullets.
I need to order some lightweight 9mm/380 bullets and I need to choose between plated or Hitek coated....
^^^^This is me!^^^^
RN bullets tear paper. SWCs punch holes. I use SWCs!
Loaded 135 9mm for use in my Hi-Point carbine.
100gr plated RMR RN bullets over 5.2gr AA#2, 1.07” COL. They run 1368fps give or take out of the...
What kind of loctite did you try? I used the red high-temp and mine has never come un-screwed.
Chronograph may be too close and is being triggered by powder/blast. I have the DLX and I typically place mine 15 feet from the muzzle and have...
My vote also. Wear the pros over foam plugs and turn the volume up to max. You should be able to hear instructions and conversations with no problem.
And where did you find one in stock? I have not seen one available in years.
Good for getting rid of fingerprints when packing away.
Most range trips. Getting better, but my left hand rate of fire is pretty slow.
Now that it is feeding, you should do this!^^^^^
Ok. Maybe the plunger tube as you suggested, or it could be the slide stop. Have you looked at it with the slide off but with the slide stop...
Does it work properly with the Wilson Combat mag?
You can take that to the bank!
You will likely never find exact brand and type of projectile for everything you want to load, but you...
Those are beautiful wood grips!
I tried Fireclean... not especially good or bad. It was hard to clean off thoroughly. Frog Lube, about the same.
Mobile 1 is easier and works...
Shoot it one handed and see if the problems go away.
I second getting a couple of good mags. Factory mags are often the cheapest a manufacturer...
Loaded up 60rds of 9mm loads for my carbine. 100gr RMR plated bullets with AA#2 powder.
Ready to chrono— will be interesting to see what kind of...
Separate names with a comma.