You are correct.. I was going to make the same post.
From the above link, CYLINDER CAPACITY: 6.0000
I don't believe that is correct.
"The Way Of The Gun"
This is the one I thought of. Scrolled down and found it already listed.
I used to sell and repair the B-3 20-30 years ago. Taken apart, cleaned and correctly oiled they clear 800fps.
6" hold over on a sparrow at 100...
Made an order and had it in 3 days.
Ammo Supply Warehouse, http://www.ammosupplywarehouse.com/cgi-bin/commerce.cgi?search=action&category=TCM0...
Was going to be my post until I scrolled down and found someone else already knows.
It's almost 90. Tear it down! I did mine, (1927) and it's not hard to do. Dried oil/dust in hidden spots. Really smoothed out the action.
Go to the link posted below from Ruger's website and scroll to "Tell the CEO".
I was given a blue streak a few months ago. Looks to be in as new condition. Made in the mid. 70's, don't remember exact year but as collector it...
Shim stock is nasty expensive.
My first was a 38 special, S&W when I was 8.
First purchase, Crosman Pellgun Single Action 44 .22 Cal CO2 Revolver
What tool are you using to make the cap???????
Pop cans always worked fine with my"Tap a Cap"
These are very nice shooting rifles. Don't fall into the weak receiver myth, that's the FR-7.
I traded a paratrooper SKS + $100 for mine. My son...
Rear sight is completely different than a CETME.
Mag housing looks to be a Mosin rather than Finish.
Yep, did the stupid thing and pushed a case into the die when it felt not right.
Sent it to RCBS and got back what looked like a new die but for...
Hey Einstein, why didn't you get a screwdriver and remove the bayonet lug screw.
You also could have knocked out the drift pins to remove the...
More difference than I remembered.
2.205" against 2.06" for the Hornady
Separate names with a comma.