While no shame, but those are typically not the best as they tend to move around while shooting.
AAA payed for that billboard for ages.................one of the worst, so folks coming to Florida need to watch for those towns.
Then buy a flat and reload afterwards
Yep and there has been zero communication regarding production timelines, employees, etc.
Not if you go to a shotgun club
Was that by chance in Waldo, Starke or Lawtey on US301? 2 of those 3 still are; Waldo had their entire department disbanded and half went to jail...
The retail store for my local range has .223, .308, 7.62x39, 45acp, 40S&W. and a host of other ammo at reasonable prices - they dropped a pallet...
As I said, both Hodgdon and Alliant have data for 3" shotshells. Go to their respective reloading data centers and fill in the blanks as to...
Briley in Houston; when it comes to chokes, they are the 800# gorilla in the room
1/2 is modified, 1/4 is IC, 3/4 is IM, 1/1 is full
M/F works fine for trap; can be a tad tight for skeet, so learn to run the gun, ;)
Both Hodgdon and Alliant have 3" data - where did you look?
You owe me a new keyboard for that!:rofl:
Plastic from some wad makers tend to leave some residue more than others; that said, it is a simple fix with a solvent, brush on a rod in a...
Had a friend lose most of his eyesight in one eye from exactly this scenario.
Read the MSDS here:...
And this could mean even a Tupperware container
There is a guy on another forum who males Pyrex hoppers; (currently I believe for shotgun reloaders) to avoid this scenario. It would be nice if...
It took me 5 shots to remember to switch my trigger finger - and I am LH to boot.
+P loads can be fairly stout in a lightweight J frame; that said both Hodgdon and Alliant have load data.
Separate names with a comma.