Sorry for the multiple posts. Still getting used to tapatalk.
The second night, seemed like the best time to get them. I didnt know if I would get another chance. The adrenaline was overwhelming. I can say...
Over the following two days I watched the tracks and wallows move further and further towards our gas wells and small gardens. I knew at this...
Went to check the water level the other day on the bayou, and noticed nice big wallows in pretty consistent chunks, expanding from the same area...
two didn't get trapped, had to shoot them out. still got skinning to do tonight.. story tomorrow.
your best bet is winnie, north of you. shoot up 45 and cross the crystal beach ferry, and when you hit i-10, go east towards beaumont. there's...
the 25$/100 remington 2 3/4 "sport" hulls that are typically 7 1/2 / 8 / 9 and 1&1/8 oz loads run fine in my mec and P/w presses, and i use AA...
I load 357 sig with once fired 357 sig from the local range, using 9mm bullets. I have found the XTPs function best. I use RCBS carbide dies. the...
And the best kind! after about a year dating, she wondered into my "hobby room" and got interested super fast, after all this time "not carrying...
switch to clays, and your issue will be alot less serious.
The m995 is a tungsten carbide penetrator armor piercing round for the 5.56/223, but is very expensive so the government doesn't stock very much...
Reverse engineering my dads favorite load from 2001. I still have every piece of brass from that lot. I just have to replace the primer, because...
This one's on me, i seem to have been under the impression 2230 is a spherical powder. Apparently 2230 AND 2460 are spherical, which is great. I...
I have tried h335 and it didn't perform as I hoped. Regular 2230 is an extruded powder and I am trying to reserve use of spherical powders, for...
Has anyone else used this powder? What calibers/results? Does anyone know anywhere it can be purchased at anymore? It was a powder...
Was this tested on not-crimped rifle brass with say 50-60% density and double base extruded/stick powders? That is where I would be concerned....
varget works great on heavier loads and bullets, But i can honestly say i have never gotten better results than H-4895. i have tried EVERYTHING,...
Welcome to THR! 1; I need a suggestion on what brand and type of pistol powder, and brand and type of primers i should start out with. .45ACP...
any rifle ammunition fired in automatics, i load on my dillon 550, along with all pistol ammunition. the bottlenecked rifle cartridges used in...
This only happens to the absolute best of us, ohiochief So welcome to the club! :banghead:
Separate names with a comma.
