I recently acquired a used, like new, 1791 holster for my 4" GP100. Hard to fully insert the revolver, due to the holster not having a sight...
I have several hundred reloads for my 1911's, that fail the plunk test in my Glock 21. Never had a problem with the 1911s. I mostly used factory...
Does RCBS, or anyone else, make PTX expanders, that can replace the Hornady PTX expanders? If so, where might I purchase them from? Thanks.
I have a question about a 20 gauge Iver Johnson shotgun. The serial # (if you can call it that) is TCXC. It is stamped on the tang, just behind...
Anyone experienced a broken Sector Gear on their Lee Auto Drum? If so, any thoughts? Did the gear fail, or was something else wrong? I...
Has anyone had any experience with the plastic ammo boxes from Harbor Freight? If so, good or bad?
I have a Blackhawk #3 pocket holster for my G42. Unfortunately the lower right of the holster bends in, and the holster loses a good part of it's...
Does anyone have any information on some older CCI Primers. I assume that they are older primers. The 1st line says "200 0012" Then the...
Anyone have an opinion about the Kahr CW380? I want one, but I understand Kahr has an unfriendly, user warranty. Is that true?
Is RWS Ammo, 380 .ACP, 95 gr FMJ Match Grade ammunition good stuff? Can the cases be re-loaded?
Anyone had any experience disassembling an Arminius hw5 cylinder & crane assembly. I assume a pin is holding the star shaft, to the ejector shaft?
Anyone have any suggestions, for the proper sequence for stripping and re-assembly of H&R DA/SA rimfire revolvers? Specifically 649, 650 and 676...
I want a belt holster, that will carry a Glock 17 high and tight to my body. What do my fellow HighRoaders suggest?
I have two questions about some ammunition that was included, when purchasing a used HC P-32. The first question is about some Fiocchi...
What state is now perceived as the "most" gun friendly?
Anyone have a manual, for a Sears, single shot, bolt action .410 shotgun. The shotgun is model 101.1120. I would like to photoopy it. I will cover...
I have a 870 Express, 20 gauge, Youth model shotgun. I want to install a sling on it. The magazine tube cap already has a hole in it. I have a...
9mm Titegroup User Questions? I have a some questions about three, 9mm, Titegroup powder loads. 1) Is 4.4 grains of Titegroup under 124 grain...
I would like to find a paddle holster for my S&W Model 60 Pro. Finding one is a problem, becaude the Pro has a 3" barrel. Thanks for any information
How much more would you be willing to pay for a Stainless vz. Blued model? How much more for the Duck Bill grip safety vs. the standard grip...
Separate names with a comma.
