factory 124 xtps are loaded to 1.070 ish.
I ordered mine on 09/07/19 and I was allowed to use the discount code. Got them for 74.99 shipped. I also got 2,000 of the 115 grain (seconds) 9mm...
I kind of have a G43x, but not really. I have a G43 and a G48 and can swap the slides around to have a G43x and a G43 long slide if desired....
They look good. Maybe a little flaking on the one on the left, but it had a lot of displaced lead from smashing. Thank you for sacrificing two...
Super sorry about not providing enough details about the "smash test". One of the test methods of checking the coating adhesion to cast bullets...
Any chance you could do a smash test on one and post a picture?
First make sure you can find a replacement spring. Parts support for the p series pistols are dying. I had to go through Ruger to get a...
With 180 grain bullets I use a mid range charge of Accurate #5, Unique, CFE Pistol, or Ramshot Silhouette, loaded to 1.125 to 1.135 depending on...
Don't have my notes on length or charge weight, but my Para 1911 shot these well with Accurate #2.
Some cast 9mm bullets have a short fat nose profile and are shorter. What you have to be concerned with is how much of the bullet is in the case...
Just an idea, but take a fired case and seat a sized bullet into the case. You may have to add a little flare to get the bullet started straight....
Your velocity adds a little light on what's going on. 1131 fps average and a max of 1151 fps. With a 4 inch barrel Hodgdon lists a velocity of...
In response to your other thread about using red dot I would suggest that you start at the .358 sizer if your gun will allow. If you already have...
With 9mm and CAST lead I have always had better luck with hp38/win 231 and slower, than what I have had with the faster powders (bullseye,...
I'll second Jack on using H4831, but I use the short cut version.
I too have been looking closely at the 43x/48. I quickly dismiss it since I have a 19,26,and 43. But every time someone else gets one at the...
Since you said "I'm starting to get into casting" I would not recommend starting off with hollow point molds. There are more factors to consider...
I'll second the Hornady case prep trio. I trim all my rimmed cases and bulk 223 rem and use it to chamfer/deburr. The insurance co pay for having...
Mine is a gen 4 that sports a TLR6. Only negatives I have is the grip texture is rough on t-shirts. Talon grips fixed that for me though. Got to...
one plus for the glock 20 is that lone wolf makes a 10mm to 40s&w conversion barrel. Friend has one and it has ran flawless. The conversion is...
Separate names with a comma.
