They answered correctly above. Put your left hand in your pocket, where it belongs, stand on your feet, and shoot like a MAN!
I don’t care about strength or cost or anything else. I bought a Benchmade Infidel because it has an unequaled cool factor.
You should carry a Colt single action army, because Jesus said “blessed are the Peacemakers”.
Am I the only person in the world who didn't have any trouble with the Ruger take-down procedure?
Headlamp, for sure. Sent from my iPhone using Tapatalk Pro
OP did not specify if he had ball c(1) or ball c(2). Are the burn rates close? Asking, because ball c(1) was simply referred to as ball c, before...
I use a brand called Wiha. Best hex drivers I have ever used.
"Best", and "not break the bank" do not belong in the same post.
Best carry gun for me ever invented.
Most people at the bench have the rest too low. Because the rest is low, they are bent over leaning into the gun. If you raise the rest, so that...
Some people cut a coil off the detent Spring, some put an o-ring on one of the brass buttons to hold tension on the plate, some put a finger on...
It needs to be BOILED LINSEED OIL, not the raw stuff. Wipe as much of the old stuff off with solvent, and put some new oil over it. You will be...
VACUUM! Damn it! At least spell it correctly.
I get the same sometimes with my Redding profile crimper. I think it is knocking the outer corner of the case neck. If I lightly chamfer the OUTER...
I don't see how a "light primer strike" can be blamed on the ammunition.
You don't see any ARs winning any bench rest matches, but I have seen some three-quarter inch ones.
When was the last time you replaced the valve springs in your car? Get the point?
MSA Sordin. Despite the "burrhead" who denigrates them without having tried them.
I did replace the crappy rear sight with a quality peep. Great gun!
Or buy some Marvelux
Separate names with a comma.
