Well, I hunt with all of my guns, including; A 1927 Winchester model 54 in "30Govt06" A 1917 Custom Remington Mod 1917 in 30.06 A 1952...
Devcon makes a whole series of epoxy/metal fillers. They are far superior to JB in every sense. Look them up on the web (Brownells carries them).
Try Numrich, they have parts and a schematic here; http://www.gunpartscorp.com/catalog/Products.aspx?catid=5678 Good luck!
I would try Brownell's Gun Kote. It is a bake on finish that is pretty tuff. You can get it in a spray can, but it is best applied with an...
I would use Kroil rather than plain oil, it leaves a superior corrosin resisting film and helps desolve the rust.
RC Please do NOT post the picture of your face after half of it is blown off:mad:
Steel is more ductile than Ti, thus it is far more suitable for applications involving concussion. Ti use in firearms should be restricted to such...
My bad (at my age relying on memory is not a good idea). The SAMMI spec for .223 is 55.000 cup, whiale the .56 spec is 62,000 cup, a still...
And the fact that the 5.56 is rated for ~30% higher pressures.
I use VFG pellets from Brownells. Their "aggressive" pellets will get out the crud/fouling (especially when used with J-B Non-embedding Bore...
Contact Boyd's Stocks, if you send them an exemplar (your old stock) they can make a new one with your choice of wood/finish. 'Taint cheap, but...
What model number is the gun?? It will be much easier to find parts with a model number rather than a "nick name"!!! Good Luck
If you don't mind me asking, what did Turnbulll charge for the blueing?? The world wonders.
This is easy to do yourself, all you need is Brownells nickle remover, a 12 volt auto type battery (deep cycle if available) jumper cables and a...
Thanks, very interesting video:):)
Any reblue willl destroy the value of the pistol. Short of sending it to Turnbull (mega-bucks) I would clean it with some 0000 steel wool an a...
While truley original, unissued GI parts are interchangable, it is unlikely that you will find them. A poorly fit barrel can make a 1911 dangerous...
Try the aerosol True Oil, one quick pass (in one direction) will avoid the problems that you are having. Brownells stocks it.. Good Luck Al...
In order to tighten the slide to frame fit you will have to peen the rails on the slide, not for the amature (it requires expensive gauges to...
Are you a right or left handed shooter? Where are you being hit (not "in the head", but "above left eye brow" e.g)? Where are your ejected rounds...
Separate names with a comma.
