60 years.Started with Lyman 310 tools.
I bought some once fired .45 ACP brass from them.No problems.
03 Springfield barrel.
I use the Nicholson pattern makers rasps from Brownells.The two I have are excellent quality.They are expensive.
I use a metal rod from a fireworks sparkler as a weight on my RCBS bench primer.
The decapper/expander plug works fine.I have a number of die sets made that way.Adjust for the amount of flare you want and you're ready to go.
I've never worked on one but a slave pin to hold the parts together might help.I assume that the trigger lock goes inside the slot in the trigger.
It is a crack.Unfortunately that doesn't appear to be a replaceable part.The schematics I looked at show it as an integral part of the barrel.Try...
Retrieving stuff from the dump here is not permitted.
I meant stainless.I prefer the ones sold by Dawn.I've used them for years.They will not remove bluing.They might remove cold blue but it doesn't...
I would use Kroil and a stainless steel pot scrubber to clean the metal parts.There is a similar scrubber sold for cleaning firearms but the pot...
Olympic Arms has not changed ownership.They cut way back on the workforce and are still surviving.MOA would be one of their average barrels.Many...
I doubt if base housing would approve.The last time I lived in base housing was during the mid 70's.We had fire safety inspections at least once...
I've been using Unique since the late 50's.I loaded some .38 Spl today using Unique.I used a RCBS Little Dandy measure and the loads I weighted to...
I use a short handled action wrench and hit the end of the handle a sharp blow with a heavy hammer.I hope you have an action wrench that is...
I doubt if you have a headspace problem.Headspace is best checked with gauges.P14 and M1917 Enfields are best checked when removed from the...
I have a RCBS Summit press.I use it for small batches of pistol ammo.I definitely would not recommend it as an only press.The Summit is a handy...
At one time I did a fair amount of parkerizing at work.We used glass beads.Sand is usually too aggressive.We used the same grade of beads that we...
Primers are probably crimped if it was military ammo.Just ream or swage primer pockets before priming.
Post this on Gunboards or the Kar98k forum.You may have better luck there.It's appears to be in military configuration from the limited photos.
Separate names with a comma.
