Nt primers ?
I've never heard of Nt primers. Is that a brand name ?
Those steel cases can be reloaded. I did it in 7.62x54r with a Lee collet neck sizer and a Lee collet rifle crimp die.
I would offer them at...
I use 'render' instead.
As in rendering fat. Melt it down and remove impurities.
It fits perfectly.
That Lee is a very popular bullet. Shouldn't be any problem finding folks with experience using it.
I respectfully disagree.
I am useing a 50/50 mix of wheel weights and range lead. Around 10 hardness, and air-cooled.
I am running these at...
Good luck with that.
Experience is nothing but the result of a series of non-fatal errors.
Could be that 800x is manufactured using old technology. There is a great deal of pressure to develop powders using more environmentally sound...
There's more than a few out there with a J-Frame Smith .32 SW Long that are reaming to 32 HR Mag.
Not the old I frame, but the J frame.
Somewhere I saw a table that showed twist rate vs length. Can't find it now. No matter, it was only a guide. Every barrel is different.
That reminds me of a poster I saw many years ago (before memes were invented).
Pic of an old, worn out old cowboy, says:
"Most of my money was...
Apparently this question has struck a collective nerve.
It took me many decades to come to the realization that the only person I can control is...
Incomplete combustion at lower pressure.
Well, there is that case of 5000 CCI Std Vel, but I already knew I had that....:thumbup:
Inventoried my 22LR.
I have more than I thought, mostly due to the 2 ammo cans full I 'found' a couple weeks ago, but less than I want.
I would buy the #9 and use it.
It's different,of course, as it's a ball powder. It won't download as well as 2400, but that doesn't sound like...
I have been waiting for the hammer to fall for a few weeks now.
Keep in mind, it's not so much the frame that can't take it.
The earlier S&W cylinders were not heat treated. The steel is nowhere near as...
The single cartridge I load most often is 7.62x54r.
Strange, but true.
About 18 months ago I was picking up 223/556 brass at the local range. One of the fellows there was mocking me, saying the stuff ain't worth...
Separate names with a comma.