For my M1 Garand I load a 150gr FMJ bullet over a charge of 46.4gr H4895 with an OAL of 3.185" .
For target work I use a 168gr match bullet over...
I have an OHAUS 10-10, an RCBS 5-0-5 and that Hornady scale. I like the Hornady 1500 a lot especially for the price.
I used a lot of W296 and 2400 until I tried A#9 which now replaced 2400.
Times are very lean, but the 8 lbs while you have the opportunity. It's...
I just might have seen my original Vaquero in for a .45 ACP cylinder.
Let us know how it shoots when you get it back.
CCI Quiet-22 #960 is very quiet, accurate in my guns. I have been using them for several years with great success. No hearing protection needed....
I don't know why everyone is posting so many different sources when Hodgdon supplies reduced rifle loads which are safe and tested. Just follow...
The green tin is the 1oz tin for $8.99 on Midway USA. The white fun is their 2oz tin for $9.99 on Midway. It's cost effective to purchase the 2oz...
If the 45 Colt dies are fairly new they should do the 454 Casull easily. It sounds like you don't have the sizing die adjusted correctly.
I agree, a firm crimp is usually necessary to develop a proper burn with slow burning pistol powders.
S&W M640 or M649 are great snub nose revolvers. I have a special run M640 from 1976 that shoots better than I do.
Safe to use. Like said above both handgun and rifle are designed for the same pressures. Now, where are the photos of your rif!e?
As usual very nice work. Thank you for sharing.
I agree, turnAround doesn't like the FTX ammo. Downloading the FTX bullet helps but very little.
I use half and half corn cob and crushed walnut shells. That works very well for me.
Nice work, thank you for sharing.
I would get a good used RCBS/Ohaus 505 or if you are willing to spend more the 10-10 is outstanding.
Two good friends needed powder and I had 12 lbs of W231. I gave each of them a pound to be replaced when powder becomes available again. That was...
That was a score. When you are nice to others it does come back to you. Well done sir.
$35 of less is my limit.
I think the performance model 686 is worth the money because it comes with an action and trigger job. It's a very nice gun IMO.
Separate names with a comma.