I used a folding table for a couple of years and a tripod stool as my portable shooting bench, though not as stable as a heavy range bench it was...
@JoelHightower welcome to the forum. Lots of knowledge and experience here. I've been loading since the mid 80's, before internet forums,...
Don't know about all states, but in NY a caplock is unloaded by removing the percussion cap, flinters by removing the pan charge. Only ed ny...
Iirc match chambers are on the minimum end of the cartridge specifications so your cartridges need to be closer to min spec. Military chambers...
General Washington spent most of the revolutionary war in retreat. With over 22,000 gun laws on the books, none of which have stopped crime or...
My rear Caldwell ear bag now has duct tape on one ear due to a friend placing the flash hider in between the two ears, but here are my bags before...
If it isn't the pearly gates, it better be a free state, Jersey is neither a light or free.
I used a 223 2 years ago with a factory round, fed premium 60 gr partition. Shot was quartering forward so the shot went in the front shoulder...
I've gotten pretty good results with 50 and 55 gr vmax as well.
I use bags front and rearostly, but bipod and rear bag isn't far behind. I do a lot of shooting at 300 meters spring through fall to prep for...
I don't know too much about them going back past mid 80's.
I took a short walk after a half hour drive. Had to take my 58 Remington to the doctor. I broke the loaf g lever screw a while ago this is the...
Being of sound mind I shoot them all.
I've been loading blc2, h4895, and imr 4895 in 223 for years. The heaviest I've loaded is 68 gr hornandy match bullets, but get great accuracy...
@Majja13 welcome to the forum. Is it the lop or scope position? You could try a set of offset to go to move the scope farther back. What rifle...
@Cookie223 welcome to the forum. Since your question has been answered I won't extrapolate any farther.
I've got the glenfield m60 with squirrel stock, my wife claimed it as hers and a pre rem m60 in wood as well that is a gift to my grandson....
Selling reloading supplies? Don't need? Some of us are always looking for more supplies.
Welcome back to you the forum from a fellow NY'er.
It didn't affect me either, had several loads worked up for 4 rifles with plenty of components to load more. Plus I shot about once a week from...
Separate names with a comma.