Pull a couple bullets and see if the case will chamber as it is. It kinda looks like there is still some swelling near the base, like it wasn’t...
I load a homecast 158 swc over 5.0 grains of bullseye to shoot in a 6” GP-100 and it is a nice, mild target round. Love it and have fired...
Some powders just don’t like to cooperate and work with many powder measures. Any extruded powder I use gets scooped close and trickled to finish....
I picked up some 223 & 9mm brass last week at a place I shoot out in the woods, and there is one big flat rock about 125 yards long and maybe 40...
I still do most of my loading on a Lee Reloader press and I’m on my third one in 20 years. I did break the first 2, once on a stubborn 308, and...
I’m not, I haven’t had to shop for components for a couple years. I have seen then here and there at reasonable prices, but after 30+ years, I...
No help on this one? I wouldn’t have thought it would be that hard, but I’m not finding one.
For those wanting to reload and don’t have much of a budget, fear not, it can be done. This is not the best time to start, but it can still be...
I started in 89 because I wanted to improve the performance of a TC Contender and someone told me I could do that by loading them myself. I...
Never get complacent, double check everything, if anything doesn’t look right, it probably isn’t. Trust, but verify. Add more light. Use known...
He is loading them for a Henry, so I’d say a rifle. Plated will work for plinking, but like you found out, jacketed for top velocity.
Arfcom is ar-15 dot com for those that don’t know. Lots of knowledge there, but lots of bs to dig through to find it and lots of attitude and...
We all have been there at some point. Even after doing it for many years, it can happen, it shouldn’t happen, but sometimes it does when we loose...
Maybe I should clarify, I refer folks that I feel would benefit this community, want to learn, and have manners. It may only be 10-15 that I refer...
I used the Lee 3 die set to load 308 for years in a CETME and a Rem700 PSS. I got them both loaded to their liking and both were exceptionally...
I cast and coat the Lee 124 2R bullet and the Lee 124 TL TC and shoot it in an 8” AR-9, Glock 17, 2 Springfield Range Officers, and a Ruger SR9C....
I have been referring folks here for years. It is truly a great place to hang out and learn how to do things right without all the bs other forums...
what I’m looking for is similar to the pictured pouch below, but with the round holder sized for 223, not 308 or larger. I’ll probably get one of...
With 9mm I get all my brass from the range, so I grab all I can and get home. It gets deprimed, swaged, wet tumbled, resized, primed, and stored....
Every die I have ever owned in 30+ years has been the standard Lee dies, some 3 die sets, some 4. Never have I felt the need to buy any better...
Separate names with a comma.
