I appreciate the follow-up AA.
What's your source for this information?
I may have gotten lucky but my Gen 5 G23 will do better than that offhand at 25y or braced at 50y with 180GDHP. Best of luck with whatever path...
Would it be possible to edit the thread title?
What problems were you seeing with the extractor(s)?
No Sir, not at all. I, at 59 y/o, use 1.0 readers a lot for reading and they help quite a bit when shooting iron sights. They also sharpen up...
Well, looking at the thread title I thought about the Safelite jingle:
Wal-Mart readers @ 3 for $8.98+tax.
Ball cap, toboggan, hoodie, etc?
Soooo, who's going to start the "Best Handgun Caliber For Cougar" thread?
Speaking from the perspective of a person that CCWs a Trijicon RMR 07, the only worry that you'll have is hitting it with a lens pen when needed....
I've seen them used for 55rds of linked 25mm.
Are you allowing time for cooling between shots/groups?
I was finally able to get this revolver in for diagnosis and repair. Thankfully, it ended up being only a trigger spring. Again, I really...
IME the 23.5 works just fine in my JMCK kydex holsters, as did my 23RTF, as has my 19.5 and as does my G45
Plenty of those 30rd AR mag sleeves on or in cases do a very serviceable job of holding two 20rd AR when stacked.
Owning T2 sights in 2 & 4moa along with a 4moa PA that I bought used I agree with the above post. I run the PA on a 22lr AR and my only change in...
Thanks guys, I really appreciate the help with this.
A bit off topic but definitely related to the revolver. I've been trying to communicate with...
Jackrabbit1957, you are The Man, as shown below.
1. Does the cylinder free spin with hammer down and the loading gate open?
2. If the...
I start with the badminton swatter but then move to co2 powered bb launchers (low hit ratio) if needed. If they don't take the hint I move on to...
Separate names with a comma.