Apparently my transaction didn't go through. Fine with me.
A friend was looking for LP primers. I did find some Winchester for $186/1000. He said...
I just ordered. Great prices, flat rate shipping. They only have a 27.6 rating out of 100 though.
pieceedge.com Review - Scam Detector...
Edit: HUNTING load (sorry)
I don't hunt with that round but I do like the 75 Speer Gold Dot.
Well, the bullet is 1.2 inches long and is loaded ahead of 15.5 grains of ball powder of some sort.
I just picked up a couple more boxes of these at Sporstmans Warehouse:
I've carried the G42 with flat points and hollow points occasionally. I believe the round is effective with either load.
Guides carry Glock 20s in 10mm for Polar bears that make it to northern Iceland. l would rather carry something in 10mm than any 45 ACP caliber.
My AR9 uses Glock mags and won't reliably feed certain bullets. XTPs feed fine but the X-Treme JHPs won't feed at all because they are too blunt....
Okay the all-knowing internet found this:
.30-06 Springfield Part 2 - Service Rifle Loads — Proven Reloads and Handloads...
I have a lot of 150gn Hornady FMJ-BT bullets
and H414, IMR 4895, Varget, IMR 4831, etc powders
None of my manuals have data equivalent to M2...
Colt 20 inch with irons:
50 yard zero, close at 200 with factory 123 loads or handloads. I might use 123 Gold Dot, Hornady SXT, or Sierra 125...
Well, I was being a bit sarcastic. The only one I currently have is a 30 Carbine die. I don't care for the bullet seater die because it doesn't...
Yes I have. I do use their factory crimp dies though.
I avoid Lee dies
Where were the pictures taken?
Looking at one myself. Users say 18 and 15 round mags will lock the slide back.
I would have to go with 9mm simply because as my wife and I get older it makes more sense. Add the AR9 with compatible magazines and the decision...
Yep, the best of the three.
Separate names with a comma.