No. But I don't buy from sellers that aren't well known.
In the future:
Always do a bbb check for age of company and complaints.
See how they...
I feel you on the migraines. I get them off an on. Usually in the hottest part of summer.
I learned the hard way no reloading with a migraine....
A better option would be to look in a reloading manual and see what crosses over well with multiple cartridges.
Here are 14 powders that I could...
This is supposed to be a faster burn rate than any of my other powders.
I ran into hard compression on imr3031, h4895, imr4064, 8208xbr, and...
53 is way different than the 55. I've only gotten it to shoot well jammed in the lands. I'm trying to find a powder that will work with it jumping.
I've been trying to get the VMAX to shoot in my 5.56 chambers without luck. I saw the cheap price and thought the same thing.
Anyone running this in 5.56 with 53 gr VMAX? If not I will be the guinea pig.
If that doesn't work I'll try 77 SMK's.
Set up identical targets. Shoot round Robin in ascending order. Followed by descending after the barrel cools.
Overlay the impacts from each...
I caught pine needles on fire while shooting an old fuel oil barrel with 17hmr.
We were shooting it with my 17 and my friends 22. The 17 was...
I steal my wife's nail polish;)
It works for one more round.
That used to my load. I've since moved to using jacketed data under a coated 180 wfn. This load is stout. But doesn't eat my brass.
If you chamber a 357 to 360 Dan Wesson. It puts a cast 180 grain bullet in high 1900 fps territory from a 20" barrel.
That's knocking on 30-30's...
The powder definitely makes a huge difference.
My wife liked my light 158 loads better than the 125 ones. Both were loaded with fast powders. I've never loaded wadcutters
My advice is 38 plus p...
Midway, mid south, and natchez are my primary ones. Each have their advantage.
To be honest I pretty much quit buying when the Idiocracy for into...
You would wear your arm out on the reloading press first;)
Nearly all shotgun and pistol powders will work well with that bullet.
I used universal, titegroup, and 700-x
Universal works well with standard primers.
Blue Dot works well if you shoot 158s or 180s.
CFE-P and IMR4227 didn't work well for me.
Was it your cast 2400 load? If so. Did you clean all the copper from your bore? What pistol powders do you have?
If not. Your leverevolution...
My results mirrored yours. But I went a step further. I neck turned and annealed. After that, I could grab a handful of brass and get the same...
Separate names with a comma.