Search results for query: *

Whatever you decide don't make it an S&W 625JM. I bought one about 9 years ago. Biggest piece of junk I ever owned. First problem was the trigger pull was terrible. The trigger pull guage showed it at 5-6# double action. I bought a set of Wolf springs, which brought it down to about 3#. However...

Depends on how much you want to spend. You need two pistols, a shotgun, and a rifle. You cannot use one pistol and reload under the clock. I started out cheap until I was sure I wanted to keep doing it. I got 2 Uberti Hombre .357 pistols, a 45 Colt Rossi rifle, and a 12 gauge Stoeger SxS. My...

Mine started to not go back far enough to load a primer also. Wrapped a few layers of electrical tape on the rod and the problem was solved.

Titegroup is a very fast burning and hot burning pistol powder. My guess is that you are doing some melting on the lead bullet as it goes down that long barrel. I shoot lead in a High Point 9mm using WST, and have no leading issues. My guess would be it's your powder choice. Good for...

I shoot Schofield in mine with no problems.

I use to have that problem with lead also. I started running them through a Lee factory crimp die and the problem went away.

I have a 600 JR, 650 Sizemaster, and even a 9000G once. They are a good brand of press. The #28 bushing, Winchester Super Target powder, and 1 1/8 ounce of shot in either Winchester AA hulls or Remington STP hulls will give you a nice trap load at about 1200 ft/sec. I have used that load for years.

I use 8.0 grains of Trail Boss under a 240 grain LSWC as my plinking load. Shoots great for me out to 50 yards.

I too had WST left over from my sporting clay days. I use it in 38 special, 9mm Luger, 40 S&W, and 45 ACP. I like it better than Bullseye & Unique, and it costs less at least in my neck of the woods.

The .311 bullets will work just fine. I shoot them in all of my Mosins. One thing to keep in mind is that some brands of dies for the 7.62X54R only supply a .308 neck expander and loading data for .308 bullets. It has something to do with some Mosins that were made with .308 diameter bores. If...

MissouriCrowinMass, you actually already have a perfect neck sizing die in hand for the 303 British. The 7.62X54R die with a .311 expander works great as a neck sizing die for my 303, and my 7.7 Japanese. The Russian case is wide and short compared to the 303 & 7.7 therefore they slide into the...