well long story short i am going to post some pics of this gun that has holster wear. i found it for 600 and put a deposit on it. if you guys think i should walk away let me know. your input is greatly appreciated.:p
well I haven't even cleaned it yet. All were swc or full wc and a handful of hp. This little gun didn't have one hiccup and groups are fist size and smaller with holes touching. Anybody have trigger job recommendations??:D
you need to take your drum out and clean each slide. There is a small gap in between one of them accumulating powder and then dumping causing your problems. after you clean them assemble the big to the middle to ensure full closure then you can put the thin slide on.
well I found 44.9Gr for 100 Gr bullet and 47.2 for a 87 Gr bullet. So I guess 43.5 Grains of RL15 behind a 115 bullet should be a good starting point for my work up???
Alright looked through my manuals and cant find a good load using Reloader 15 and a moly coat ballistic tip 115 Gr bullet. Please postem if you know some. Thanks
I have a new arsenal refinished Tula M44 1944 Looks mint still getting all the cosmoline out of it. picked up some winchester softpoints and they mic'd at .311 and the data online says to use .308 bullets. Please help me keep this caliber alive. Thanks
I finally had some money saved up and got me a lyman 1200 and some media. I'm like a little kid on christmas right now. Got some being cleaned and polished as I type. Dies are more expensive than my tumber was at this supply store. What is the deal??:neener:
I reload for a G27 and use hard cast lead 18 hardness with my own lube. Get a mop put some metal polish on it put a rod in a drill and polish your barrel. will not lead and cleans easier. increases accuracy too
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.