Search results for query: *

I have a 25 round mag for my 10/22 that I like to use at the range. I know the law is nothing over 10 rounds in California but recently someone told me it would be a felony if I were "caught". The rangemaster says it's okay as long as there is no rapid fire...can someone knowledgable give me...

Thanks Idaho. I'm using the barrel out of the gun as a guage and with it in the gun. When you say seat it all the way in do you mean to gently force it in to chamber? The only other bullet I have used in this gun is the swc and factory stuff. I was afraid of compacting the load going any...

I just got some mbc pinbusters and am not having much luck chambering a dummy round in my SA 1911 A1 barrel. I started out long and worked my way down to 1.200 and it still won't chamber. It stops right at the front of the rim and won't sit flush. With the barrel installed the gun will not go...

I am wondering how it goes renewing a ccw permit in a county other than the county one originally obtained the permit. The neighboring county that I am moving to is a lot tighter handing out permits (very few). Can anyone tell me their experience regarding this? I already have my permit, I'm...

Hmmm...the Lyman manual I have (49th Edition) only lists 3 loads for 45 acp cast bullets. Two are 200g and one is 225. Maybe I'm not looking in the right place?

Thanks guys. Everyone seems to be out of stock on those and I have #4 PP.

I am loading 45 acp using Power Pistol and MBC IDP#3 185g SWC. Can someone tell me what charge they have used if working with this combo? I am seeing too much variance in suggested loads (anywhere from 7.0 to 9.5 grains) Alliant website, Lyman, etc. Thank You.

Thank you for the replies.

I have a lot of small pistol primers so I bought some 45 acp brass with small primer pockets. I have load data for Power Pistol loads but everything uses large pistol primers. Can anyone tell me how or if I need to adjust my charge? Would I need to bump it up? Thank you.

I can't figure it out. Why do people stick something through the trigger guard whenever they take a picture of their gun? Like a pencil, stick, loaded round, etc.? Thanks.

Not sure if this is the right section to post this in but... I am getting some weird strike marks on my primers. Gun: xd 40 sc, only 200+- rounds through it. The gun shoots fine just seems like the firing pin isn't striking correctly. Does this look right?

I am new to reloading and am ready to hit the range in the morning with my first 4 loads. I just need a few affirmations that I am in the right ballpark here. After much reading and research this is what I have come up with (and loaded): IDP #5 180 tcfp, IDP #2 170 swc, Precision moly 170 rnf...

I purchased the Lee powder through expander (40sw) so I could use the auto disk powder measure. I have the die screwed down so that it is contacting the shell holder and it still won't flair the case (i.d. = .398). Now I am back to using my hornady expander die in the fourth hole of my classic...

Thank you all for the suggestions! Much appreciated.

Yes...is it still ok to reload like this?

I am new to reloading. I ordered the Lee Classic Turret press and a set of Hornady New Dimension dies (3 die). I got it all set up with the resizing/decapping die installed per instructions. I am reloading .40 s&w once fired brass. When I run the case into the die, it decaps properly but the...

I read about it happening everyday: suspect approaches victim, simulates or actually shows gun and demands wallet, purse, etc. My question is what to do as a ccw in this situation?