Search results for query: *

Thanks guys. That's what I thought ,but figured I best ask first. Better safe than sorry.:)

Getting ready to start reloading for a .38 special revolver, and not sure which die set to get. Should I go with roll crimp or taper crimp. None of these loads will ever be hot for the gun in question. Thanks

With the bullets crimped in the cannelure, they feed just perfectly. I've already shot about 100 rounds of this setup and haven't had any issues.

The XTP -Mag has only 1 Cannelure, according to the Hornady manual I have in front of me. The replys above made me go back and recheck everything and boy am I glad I did. Hornady Manual 7th edition has the wrong Picture shown for the XTP and the XTP-Mag. They have them switched. I am going back...

Puma '92 in 45LC. New Starline brass, Win large pistol primers, 300 grain Hornady XTP (.452), 17.6 grains of Alliant 2400. COL 1.6535. Plan on using this on Whitetail and Russian Wild Boar. Think it will get the job done?

As a newby, I must ask. Isn't 45ACP, .451" and 45LC .452" ??

The Liberator is an amazing piece of engineering. Pete has it set up so the hunter can use either a joystick, or the sip-n-puff. There are several different firearms, that can be set up on it, also. Pete told me that he plans on building a couple of new ones and taking what he has learned and...

Spent last weekend hunting Russian Boars, at Ted Nugents Sunrize Acres, in Jackson MI. As always this trip is more about meeting old friends as well as making new ones. This years trip was extra special for a couple of reasons. First, we got to spend 2 days with none other than Ted himself...

I've found a quick blast of air from my compressor gets the job done.

Thanks guys. I figured it was a non issue, just never hurts to ask.

While cleaning a batch of mixed 45ACP brass, I noticed that the flash hole size was different between the different makes of brass. I always sort my brass, and load each lot by case manufacturer. But will this flash hole size difference, have any effect on my handloads?

Thanks all. I believe I will go ahead and size it, just to be sure. Oh and by the way, great site here. I've been reading it since Christmas, already got my father-in-law to join up too.

Getting ready to start loading some 45LC. I have new Starline brass. Should I size the brass, or can I skip that step, and start priming and belling the case mouth?