Hi Everyone,
My father bought a 3rd Gen (serial# 28X,XXX) in the late 70's and it's had a few rounds through it in the last ~10 years. I fired it ~10 years ago and it was firing just fine. It's in excellent condition. I just picked it up from him and added it to my own collection. I've been...
Hi Everyone,
I have a Ruger Redhawk "Hunter" that came with 1" scope rings. I recently put a Simmons 4x32 handgun scope on it, but i didn't like the magnification and gas from the ported barrel burned part of the scope. That scope is now a scout scope on my SKS and it works great.
What...
Thanks everyone. I got a primer pocket uniformer and now the primers sit flush or a little below flush and chamber easily. I didn't realize using the cheap Armscor 55gr FMJBT bullets would destroy my accuracy. I'm going to pick up some match grade bullets and try again.
Many thanks, I'll order a primer uniformer ASAP. I was a bit upset since i ordered 200 factory rounds for $13 a box and was hoping to just reload them.
Brilliant. I never thought of that. I did notice that my primers were sticking out a tiny bit more than usual despite being seated well. Any ideas as to what the solution is? Trim the case a bit more?
Dear Board,
First post. I just got into reloading again after my father had taught me back when i was ~15yo (I'm 26 now) using his lyman 300 tool and dies.
For my 22-250 (Ruger M77 Mark II Target), after firing my S&B factory rounds, i decided to neck re-size only those cases with my Lee...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.