Search results for query: *

I would love to see more on this because I live in Indiana and store in my garage. One of my favorite sayings is "if you dont like the weather, stick around...it will change.

I think the Tula is steel meaning non re-loadable.

+1 for the RCBS Chargemaster.

I think this thread turned a little south but I an very thankful for the help I get when I ask a Question...I check this forum and a couple of others every day and hope for answers to questions I have so I dont have to start a new thread because IMO the search function doesnt work very well.

Walmart Got these from Walmart, they also make them in twice as tall which I need to get for my 40 cal.

I have a Rockchucker Supreme and love it...But I am not in a big hurry, I like to check every round I make whether it is rifle or pistol so I dont mind the single stage press. I reload most of my ammo in the winter when I have nothing else to do. Although the first thing I did was get a Charge...

My Bench I used this thread a bunch when I built my bench. It is 42" off the floor and solid as a rock. The second bench is not as tall but 16' long, I use it for case prep. I also have a 48" square table. I have a computer, TV, Stereo, Fridge in my Man Cave. If I could only figure out how...

Thanks for all the help guys...I will start pulling them this weekend.

I just pulled two of them and the cases are shorter than the trim to length in the book. Did they not get enough crimp?

If the bullets were over crimped and I pull them will I be able to reuse them?

I got a bunch of Montana Gold .40 cal 165 GR HP that a friend reloaded in mixed brass and nickel for me. After shooting some with no issues I started to open up the unfired ammo boxes and noticed that there were several shells in each box that were quite a bit shorter. Upon futher inspection I...

If you are not using electronics then it is probably not going to be a problem...I know my electronic caliper and RCBS combo get pissy if it gets below 60.

Where do you get 7.62x39 brass? I was wondering where you guys even get the brass to crimp...I have been looking and it seems very expensive as compared to some of the others I reload for.