Search results for query: *

I have a bulgarian mak that I converted to .380, so far i've only put 100 rounds through it but it functions just like it did with 9x18. good guns

remington 582 heritage .22 revolver 4" bbl

sportsmans warehouse has a bunch of blackpowder stuff, it's located right outside of boise. As for a range I don't know, theres enough open space around here I don't think a lot of people bother with ranges

I guess i'm in the minority, I found the trigger too soft and "squishy" for me. I also had problems with the bullet jamming against the barrell and not feeding. Otoh, it shot very well and was quite comfortable to ccw. I ended up getting rid of it in favor of a mak.

Mods please move this if necessary, I didn't think this belonged in general discussion. I just saw this in a local news story, so I cannot verify it. However the news was that jane fonda and her daughter are going to be going to iraq to protest this war. You woulda thought she had enough of this...

s&w 19-5 4" barrel. The cylinder is getting a little stiff from build-up, how do I go about removing the cylinder to clean and lube it? I know how top get the cylinder assembly off the frame, further than that I don't know.

I just wanted to make sure that was how they were supposed tio be. thanks all

recently I picked up a box of 148 grain lead wadcutters, unknown brand. They are covered in some sort of yellowish lube that almost reminds me of cosmoline. All the lead bullets i've usedd before have had a lube ring but have been clean otherwise. Should I leave the lube in the grooves but...

thanks

picked up a blued 4" model 19-5 with adjsuttable sights today, $330.00 out the door. Overall it seems to eb in excellent condition, there si soem blueing wear around the end of the barrel and the cylinder but that seems normal. It came with a set of pachmeyer grips. The serial number is...

whm1974, thats all i've been able to put through it so far.

7 shot taurus 817. 1000 rounds and no issues.

my 817 doesn't seem to have any probl;em with +p's, the grip does a pretty good job of soaking up the recoil.

I'll look into that, thanks. It just seemed odd that I would have that problem with only that brand of brass. Also I'm a terrible pack rat and would hate to have to get rid of the stuff

I just built up 100 round of 125 gr lead .38 special using a mix of winchester, r-p and IVI brass. I noticed that out of 50 rounds built with the IVI brass almost 30 bulged aroudn the bullet and would not feed into the revolver. I did not have this problem with any of the other brands. Is this...

okay so fish or burro canyon are the places to go then I take it. For handghun shooting which would be preferred? I drove out yesterday, nice drive but online map directions suck. For some reason they routed me though death valley :confused: Anyways i'll be headed out to one of the two on...

I want to pull the cylinder to lube the shaft but i'm not seeing a way to do it and the manual isn't very helpful. Anyone done this before?

please delete found what I needed by searching

headed to las angeles to visit the folks, then on to pacifica to visit soem friends, then sacramento for a few more firends and then back to idaho. On a related note, anybody know of any shooting ranges around monrovia, ca?

i'm headed up to cali for x-mas and am planning on bring my .38 and my .22 revolver with to do some shooting with my dad. As I understnad these need to be carried in a locked case unloaded, that right?