Recommendation: Do NOT shoot a round unless you KNOW it is within spec...ie. not too long. You run the risk of the chamber squeezing down on the brass and holding the bullet where it is hard to release upon firing...pressures at that point could be VERY DANGEROUS! A shooter could wind up wearing...
Ranges
You might like the Faribault Rifle and Pistol Club Range. Its out in the beautiful country to start with...it has I think 7 or 8 pistol pits (I don't shoot much pistol but there are a lot of guys there who do and have occasional matches). The rifle range goes from 50 yards out to 600...
I recently read that Minnesota became a state in 1885. It was originally started by a wayward group of of Norwegians who fled the unbearable heat of Wisconsin winters.
If you ever plan to reload your own ammo...take a quick look at a .284 Winchester cartridge...short action...7mm bullet...very close in performance to a 7 Rem mag
Sightron SII are very under rated as far as tracking and clarity. It seems as though most of the average shooters only know Leupod and Tasco. I've had 2 Sightron SII's since Sightrons first became an American product. They are both very clear and have tracked perfectly. I've shot 1 1/4 inch...
A question maybe....Which factory action do most top custom rifles prefer for strength, reliability, resale etc.?? Also which factory action do the Marine snipers rely on with their life? To answer these questions might help in your quest......Best Wishes
Hi there...I have loade the 22 250 for many years but always still learning. Have you messed around yet with the seating depth of your bullets? can make a big difference. Also do you turn the case necks and check for concentricity?....another helper...do you uniform primer pockets? and seat...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.