Search results for query: *

guide rod orientation Definitely get the guide rod in correctly. from the manual: Carefully insert recoil spring into hole in rear of slide, and compress the recoil spring until the end of the buffer guide rod can be reinserted into the buffer bushing (the projection on the guide rod...

oldest rifle 1917 Winchester 1906 22 pump

lucky me I recently inherited a '63 .243 featherweight with a Weaver K4. not a virgin fer sure but a darn nice looking rifle. Dying to shoot it - soon as the hay is cut and I can get to my back pasture range without trampling the grass I'll give it a go. Mitch

possible ID [probably] a Benet primed .45-70 round. These were designed in the late 1860s by Colonel S.V. Benet at the Frankfort Arsenal. Used in U.S. military handgun and rifle cartridges, the system involved a copper or iron cup that was crimped inside of the case head. The cup was actually...

not centerfire, no primer primer, no headstamps bullet dia .445 ( round nose flat point ) measured at case mouth overall length 2.557 rim dia .601-602 rim thickness 0.066 Step (like belt, but right up against rim) dia .501 case .490 taper from 'belt' to .485 at mouth brass oal 2.088...

bodyguard David Rose had em on his Billboard last month - near Fayetteville Arkansas.

vote for Kimber I've had a Kimber Ultra CDP 45 for 10 years - never a single glitch. Carry it a lot and run 25-50 rounds thru it once or twice a year and use it for carry license qualifying. Shoots better than I do, 25 oz +/- - pretty sweet. Figured Kimber needed a vote on this question ;-)...

thanks!!! Ah - great, thanks folks. Knew it would be simple ... Getting it back together was a bit tricky too - but just a matter of patience and coordination. Got two mags in today , Triple K's from Cheaper than Dirt. One goes in and out just fine, the other wants to stay & needs, um...

Anyone have the process for "normal" take down of a Raven 25 ACP? Just acquired one, no mag / no manual ... TIA, gpa mitch

re: Rugers Makes my mouth water - but I already have a vaquero in each caliber & doubt I could convince my wife I need two ... so like the man says, check prices on the major auction sites, including Cabela's gpa mitch

Safe safe location I'd go for the basement where you can bolt the safe to the concrete floor. Mitch

re: gun safes Mind you check the dimensions - my Heritage 30x60 has 17 long guns and room for a few more, but the top shelf means longer long guns can only go in front. So my Lyman Great Plains .50, Browning 7Mag, old Reminginton and Winchester Shotguns have to be in the front row as they are...