This is an area with which I have NO KNOWLEDGE. I'm searching for answers and this is intended to be a SERIOUS question on my part. The following is not intended to be 100% correct and I've made certain assumptions ... but the point is to find out what our members think.
In terms of...
I just saw a story on the nightly news that today's "run-of-the-mill" (but very high tech) scanners, copiers and printers are capable of producing counterfit bills that are easily passed to the unwary without some close scrutiny.
That got me to thinking ... isn't about time that the...
I've been using H/IMR 4895 for my rifle reloading (6.5 thru 8mm with 140-150gr bullets) and am looking for a good, all-round alternate powder. I currently have 3031 ... 4064 ... Benchmark. Given my situation, what would YOU pick?:confused:
I'm looking for the typical pressure for this cartridge. I have a load in mind:
22.0gr IMR 4227 with a 125gr JHP.
I just plink with it, rather than trying to vaporize the bullet halfway down the range.
Thanks!
I was wondering just what kind of pressure levels one should expect with this cartridge. I don't have any specific loads in mind at this point, but would like to get some kind of range as well as what single shot rifles would make acceptable firearms for it. I have a H&R Handi-rifle in this...
Who's got some loading data using Benchmark with a 128gr original FMJ bullet?
I have loads for aftermarket bullets ... 123gr @ 33.3gr and 150gr @ 31.0gr ... I'm thinking a starting load might be OK at say, 32.0gr?
Your input is appreciated.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.