Search results for query: *

"I suppose I could live with the stock, and maybe they will add more barrel choices to the line if the gun really takes off (too bad the old Fox Hill(?) custom shop isn't around anymore, they could have offered a good alternative source for other, less popular, caliber choices.)." [Fox Ridge...

I was thinking about getting a new rifle chambered in .25-06 Remington but the specific rifle that I would get it in only has a 22'' barrel. Based off this quote from Glenn Harmaning from a Chuck Hawks summary on the cartridge, I got a little worried. "The worst that can be said about...

T/C has really taken the the "Interchangeability Market" by storm. This being the first bolt action multiple shot, that I know of, in the market is quit the technological advance in the shooting world. I, unfortunately, believe that this first edition of the Dimension rifle may take a nose dive...

Someone has already started this thread, sorry. http://www.thehighroad.org/showthread.php?t=637833

I have recently decided to purchase a rifle chambered in .243 Winchester. I have narrowed my choice down to two rifles and though one has more "options" and appeal to me, I just wanted to get everyone's opinion and/or experience with rates of twist. One rifle has a 1:10 twist rate while the...

I have recently been thinking of a new caliber to add to my selection. Some time ago I was researching some "small" calibers for flat trajectory long range shooting/plinking but mainly for coyotes. I narrowed this search by deciding on a short action cartridge (I already own a 30-06 for larger...

I was setting myself up to load some ammo for the first time and after tumbling/cleaning, sizing/depriming, and cleaning the primer pockets I came to measuring the powder. I have the Lee perfect powder measure and the Lee safety scale. I read the instructions for both the powder measure and...

I just began reloading some Winchester/Remington once fired 30-06 cases with a Lee full length sizing die and noticed an impression ring that formed below the shoulder. As the instructions depicted for setting the die: I raised the ram all the way up and screwed the die until it made contact...