"On the second one it's gota be a EBR of some sort id like a ak but as of right now they are a bit too expensive for well aks (wish i grabid a yugo from j&g a while back). So im left with a ar and this this is where i really need ideas as there are only 8 million places I can get ar parts and...
Only buy 100 primers to test with instead of 1000 would be my advice.
It is interesting that Winchester doesn't make a SRM, but CCI does and also makes the No. 41 5.56 NATO which is a magnum. Perhaps the No. 41 is used only in specific types of ammo for the military? You know CCI isn't making...
I only load 50-100 per caliber. Keeping all the loading components on hand is what I like. With quite a few guns to cycle through when going shooting don't need a lot reloads on hand.
With just components on the shelf load changes are easy, a primer swap, different seating depth and so on...
I'm a former owner of a IO Inc. aka Inter Ordnance manufactured Sept. 2014. It was the biggest POS ever. I now own an Arsenal SLR107FR and have never looked back. :D
JonB, I am sorry for being an a**hole toward you, my friends say I'm a nice a**hole if that helps.
Not marketing hype, I'm an owner and user. Here are a couple links covering the press & priming system in detail.
Forster CoAx Press Review 13:58
https://www.youtube.com/watch?v=NEzVZe7f6G0...
A 357 Magnum is not considered a big-bore but is a must have for any big-bore lover which is usually considered .40 and up in caliber. It's the high pressure and breaking the sound barrier making the really loud noise on the hot loads; somewhere around 1100fps.
Your groups look very good at...
Opinions and cheap talk is most of what forums are if you haven't figured that out yet. People do like to change definitions on the fly. I to have Glocks, 1911s and do my own custom gunsmithing.
What I hear is just cheap talk & opinions as usual from a internet forum. The last few posts are...
Not cleaning the lube off the inside of the case necks. Lube between bullet jacket and neck reduces bullet pull; can cause setback on autos, erratic ignition & increased extreme spread. I'd be rethinking that one?
It's an excellent write up on AR's. It tells a lot of what we already knew too, and that is keep it lubed, keep it clean, replace bolts, cam pins, gas tubes, etc. often and after 100,000 rounds you should have a usable upper and lower.
A Glock out of the box is more accurate & precise than a out of the box non-custom 1911. And a whole lot more reliable but we don't care about that in this thread. It's not until a lot of work and dollars are put into a 1911 will it pull ahead. Otherwise it's just combat accurate (aka able to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.