OK. Here is more info.
I seated bullet to a depth that allows round to be loaded in barrel. OAL measured is 1.093''
About powder charge. I used maximum load for 9 mm from Lee handloading book. Where maximum charge is 4.6 gr
Also, on TiteGroup bottle label it is using 4.8 gr for 115 gr...
4.6 grains of TiteGroup and later I used 4.1 grains....
I'll try to load some new ones to 3.6 grains first and then working it up. And I would need to see how shortened length of round would affect how rounds are being loaded in handgun.
On crazy side I have Hi-Point carbine in 9mm, so I...
I'll try to re-seat bullet with smaller charge. It makes sense to seat deeper. I would wonder what kind of pressure to expect from such a load?
How do you calculate reduction of powder charge?
I lube my bullets with lee alox without sizing die. That is getting bullets into small metal box and adding some lube. Then shaking them for a while.
I would also need to check on OAL. One thing I noticed is that not all of the rounds were equal length. By this I mean that there is small...
I would need an advice on how to handle this situation.
I've used Lee 2-bullet mold for round nose bullets to cast around 300 bullets and loaded them into cartridges, with primers and powder.
Now, I come to range and load my first round into my handgun and.... it doesn't even load it into...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.