Hi all,
My Lapua 338 brass comes out of my gun with a neck runout of +/-.001", when I run it through the Redding neck sizing bushing die it comes out at +/-.004". I've tried 2 different bushings, with and without the neck expander ball, with and without mica. Cleaned die completely and...
I just bought quickload. I am trying to figure out a way to set distance to lands. One of my main objectives was to see by adjusting seating distance from land what the pressure results would be. Is this possible with quickload??
Thanks!
I have the same gun. DPMS LR308 24"
Lapua Brass
178gr A-max
44.5gr Varget
CCI LRP
2680fps
Shoot it 1/2 moa out to 300, moa out to 800, and about 1 1/4 at 1000
Hi,
Just got my 550 today and having a few issues. First it says to adjust your resizing die by screwing it down until it touches shell plate. Fine. But that little cartridge spring there after rides on top of the shell plate thus being smashed between die and shell plate. Obviously I'm doing...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.