Search results for query: *

XDS 45, love it.

thanks, I'll give it a try.

HI, I want to put a scope on my TC & have a couple of ?s. How to remove the rear factory sight and what do any of you prefer on the base & rings as to brands? Will the existing screw holes match up with the base mount? Looking at the weaver elite 2-6 power. Thanks Tim

Old/newbie here, so you can full length & neck size from the same die? I don't need a seperate neck sizing die? Thanks Tim

Thanks, I will check these out. I have already checked Bullberry, they didn't have anything.

OK, just got interested in is cart but can't seem to find a 10 or 14 " barrel. Can anybody help me find one. Prefer the 10". but will entertain the 14. I don't have the frame yet so either G1 or G2 will be OK. Thanks Tim

where to find a 7mmtcu in 10" OK, decided I want this gun. I can't seem to find it anywhere, has this caliber been discontinued or am I just not looking in the right places? Thanks to anybody that can help me find one. Seems that TC has gone to the 12" and I don't see the 7mmtcu listed. Tim

I think I wll go this route, What dies and other accessories will I need. I only have pistol reloading dies . Thanks Tim

Getting more interesting! I will take a closer look at this set-up if that is all that there is to it. What size bullets and powder do you use? Thanks Tim

This looks interesting. I might do something like this later, the brass for this load is expensive. Midway had it for $35.00 for 20. The SBH loads are more in my line as I have about a 100 left over from about 30 years ago. I had a TC back then also chambered in 44 mag and a 14" in 30 30. Wish I...

not sure what field pistol is, but i will be shooting 200 meters ,open sights, standing.

Going to try my luck at this competition. Need some input on a potent & accurate round. I will be shooting a Colt Python with a 6" barrel, it's the only gun I have that is suitable for this type of shooting. Just trying it for the fun of shooting long range. Bullet size & shape along with a...

This one's kinda shinny.

What length barrels do they use. I have a Colt Python 357, but it only has a 6" barrel with an 8" sight radius. Tim

Hi, does a 44 mag have a chance in this competition? If so, what loads would be good. I reload and cast my own. Figure heavy jacket softpoints probably wood be better-or not? I used to have a Ruger Super Blackhawk 30 years ago and really liked it. I have a hankering for another one. Not really...

Guys ask me if it is an original and I tell them no- just neglect on my part. Shame on me! Luckily the insides had plenty of oil and stayed covered through the years. Tim

I'm next! This is my entry. 1858 was bought in kit form about 30 years ago. Since then the cold bluing has worn off and has not been shot for about 15 years( to amount to anything.) Getting back into shooting/reloading/casting boolits again since I have found a range about 20 miles away that...

My Mom work at a sewing factory that made denim jeans and wood bring me some scraps that I would stuff and cut at the barrel

Kahr P380 with XTP-HP.

Just bought a used CW9 2 weeks ago, love it so far. It goes bang on every type of load I feed it. I would like to have a different rear site but not that big of a deal. TIm