so i just re-read the op and update a little more carefully. when disassembled the forend and bolt should not just come out i should have mentioned that in my reply i assumed and we all know what that does. there are two springs in the area where you load the magazine that should keep it from...
OK. first get on youtube and watch a complete disassembly video as i can not accurately describe the process all of the internal parts to the point you will be able to understand them by typing. and since you've had it apart make sure it's back together correctly, not doubting your skill but...
time to tie our boots tight
my fellow red blooded americans. it is time to stand up and fight for our rights. this is the last straw. and they are about to go too far. i am merely a hillbilly from the mountains of nc and i'm scared. i know i'm beating a dead horse, but i cant wrap my head...
ok i have no dealings with this coating. i have however screwed up alot in my new quest of gunsmithing. so the first rule is to not make things worse. so dont do anything your unsure of if it sounds stupid it probably is. there are smart people on here so just read all the advice and pick out...
thanks for the help yes i do have that spring back in there. i at first thought that i had it in wrong but i best i can tell there is only one possible way. i have disassembled and reassembled the gun several times to make sure everything was in alignment and best i can tell it is. i'm at a...
i am a new gunsmith. i did a cleaning job on an FEG P9R. put back together and gave it a safety check, all works. gave it a few dry fires to double check. and the hammer catches in the half cock position not falling completely. it does not do it every time just about every 3rd or 4th time in DA...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.