Search results for query: *

I don’t see anything wrong with any of it. Looks like a good price for what you get. And “oh gasp” I think the pistol looks pretty good. Would get one for my wife if we didn’t live in commie Canada.

I’ve had both shoulders done as they were both ripped badly especially the right one. Even though they are both so much better than when they were ripped my days of shooting a pistol one handed are long over. Course being 67 doesn’t help either.

I tried lubing the Glock 44 I have the way Glock said to and had issues with some cheaper ammo. Started lubing it like I do with a 1911 and it hasn’t had any issues with any ammo I shoot now.

I have some Federal and Winchester 38 special brass that has been loaded so much the head stamps are getting hard to read.

Don’t know if it would help your situation or not but every now and then I run some powder graphite through all my powder measures and make sure to get some on the plastic hopper as well. I live in a very dry climate most of the time and static can be an issue here. With the graphite it stops...

I have three Hornady powder measures two on LNL AP presses and one on a powder stand and have never had that happen. I also use a lot of Bullseye in all three. Am I assuming correctly that you painted the inside of the body above the rotor?

Have you tried Unique or Herco in it?

Does anyone remember the kinetic bullet puller made from iron pipe that I believe was in an NRA article from years ago? I had the instructions on building it but can’t find them.

What I’ve always enjoyed about Paul is when he goes after the losers who try to trash him.

Best one yet.👍

I have several dozen each of S&B 9mm and 38/357 brass that I’ve had same issue with. They are all in the oddball brass can.

Consider yourself lucky that you can get a supressor.

I wouldn’t shoot the wad cutters but disassemble them. As far as them and the primed brass try a couple to see if primers fire then load some test loads.

Lee U die works for me. I had several thousand once fired American Eagle brass from several cases of new ammo I bought that no matter what I tried with Hornady or RCBS dies I had setback. The U die solved that issue for me. Those cases have been loaded several times and haven’t had any splits yet.

I don’t worry about the cost as I enjoy casting, reloading and shooting. I haven’t smoked or drank for decades and the money I saved from not doing either more than pays for it plus I’m healthier and happier.

I enjoy all I reload for but reloading 45 Colt is by far my favorite.

I do have a 3D printer but it’s at my sons. He has made some things that have worked but I don’t have the will or brain power these days to mess with it. It takes a long time to make things on it as it’s a lower end unit.

Ha ha I near spewed coffee all over when I went to that site.

Has anyone dealt with them before? I have been looking at his 3D printed case feeder for another Hornady LNL i recently purchased. Had a couple emails with him and nothing going on two weeks. It’s a bit pricey and with shipping is getting close to what a Hornady case feeder would cost. It does...