Finally got all the parts the other day to build my Worlds Finest Trimmer project.
Always want a way to control brass shavings and trim brass with only using one hand.
I have never seen this before until today. Is this a factory thing or is the brass garbage? Case has a marking of G.F.L.
I found one the other day and the plug was missing, figured it was a bad case and tossed it.
What do you guys do with the 1 or 2 extra bullets you usually get in a box of a hundred?
Get the primers needed out of a new box, or just set a side for later use?
Just noticed that about half of my fresh loaded rounds using a 7-1/2 rem primers are not seating all the way.
No problem on Winchester and PMC brass.
Anybody have a solution? All the brass has be swaged and clean.
Just figured I would try them out, I bought a 25lbs bag of walnut shells.
Threw in about a quarter of a bag in my big Dillon tumbler and then added around 900 40SW cases and about a capfull of nu-finish.
After about 3 hours, the cases are clean but are not as shiny clean as I would have...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.