Thanks RC! I think I got it down.. just had a hard time actually finding a demo of how to set it right. All 5 rounds I've made up have passed the "plunk" test and have cycled out of my magazine and through the chamber and ejected just fine with no hang ups. Now just going to go shoot them all...
I've gone through all the stages with all the research but the bullet seating has been causing problems. I've done the minor adjustments and seated the bullet to the COL specified in my data but once I've achieved that the case is just slightly bulged past the .423" I'm not sure what i'm doing...
rcmodel,
Thank you for all your help!
I have two questions just to ensure that I'm being safe.
1.) The powder I have is Alliant Reloader 10x, you are writing RX-10 I just want to make sure their the same
2.) The Max load for the data you shared is more grains for a lighter bullet.. just want...
Thank you all!
So what I'm understanding here is Pick a middle "safe" point, Magnum primers don't effect much over all if i'm starting at a lower charge but within min/max load range and work to larger loads watching for pressure signs until i find a happy point? 20.7 grains with alliant...
I'm handloading for my AR-15 and have Alliant Reloader 10x powder, Speer 50 gr SP bullets, CCI 450(magnum) primers and cannot find any load data that covers what I can get my hands on these days. Most of what I can find during my research is to take the min load and back off 10% to compensate...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.