Search results for query: *

Anybody have good recent experience with Barnes TTSX 165g reloading? Looking for a powder selection for a 30-06 with this bullet Thanks! P

Working up a load for Barnes TTSX 62g in 223 for a DPMS Barnes load data states a COAL of 2.25 and recommends 0.05 off the lands so in theory I'd start with 2.25 - 0.05 = 2.2" COAL Using a gauge I measure 2.392 base to end of plastic tip which is a mile longer. Just for fun I measured base to...

Got this off Barnes website ... Lots of different powders to try. I'd prefer to find someone that has tried one or two powders give me an assessment. Otherwise I'm gonna be buying a lot of powder! Anyone tried any of these? As usual per Barnes TSX bullets I need to push them as fast as...

Any of ya'll have one of these? I've been wanting one for a while and I'm about ready to jump ... Just wanted to see if any of ya'll had any experience with them. They are rated highly on eBay and Amazon ... Lyman GEN6 Compact Touch Screen Powder System

If you could have just one powder for both 308 and 30-06 what would it be and why? I've got an opportunity to score a free 8 lb bottle of my choice due to fantastic customer service at Hodgdon (long story). So far I'm thinking IMR4895, IMR4064, or H4350 Only issue I've seen with 4350 is it...

I recently acquired a Tikka T3 Compact in 308 and have attempted to reload for it. I went according to the Nosler 2014 tables here for the 150g (I'm using Barnes TSX). I loaded rounds with 44g, 44.5g, 45g, 45.5g, and 46g IMR 4064 and fired them at a 100 yard target. I'm getting 1/4 MOA with the...

I found a bunch of what appears to be nickel casings, see picture bottom casing. Can I reload these? Are there any issues I need to take into account if I do?

I've got a Lee 25th kit with 243 and 30-06 dies. I've deprimed/straightened 300+ cartridges without an issue. THEN I read that I need to lubricate the cartridges before running them through the neck resizing die ... Oops ... Really, I haven't had a single cartridge get stuck. What kids of...

Is there a simple way to clean brass without the expense of a tumbler? Looking for a way to get the grime/stuff off the casing so the performance isnt effected. Shiny brass would be nice but its not a requirement for me

So the charge tables I used to prep my reloads shows an [estimated] speed in FPS. What equipment do you guys use to actually measure the velocity of your reloads?

Just curious, are the Lee and RCBS presses threaded the same? Can I use RCBS dies in a Lee press vice versa?

New to reloading, looking for advice on selecting 30-06 reloading brass. I see several manufacturers at MidWay ... Before I go and buy the cheapest I find I thought I'd ask you guys to weigh in on the pros/cons of each ... Lapua Norma Winchester Remington Hornady Nosler Quality Thanks! P

I'm new to reloading and I'm working on my first set of rounds. I'm a little short on cash to buy a Hornady reloading manual but plan to soon because I really like what I hear about the 165g SST for deer hunting. Can someone look in their Hornady manual and hit me up with load recipes for these...