Search results for query: *

i clean mine at the rear of my van, in driveway.. i then use the compressed air to blow parts clean and then dry. i hold long rifles tight against my body till i get there. or use a big towel for a little cover, i know ive been seen by my neighbors anyway. open the doors and spray away. its my...

i think we still have to keep our voices heard and talk to other people to fill them in... some just dont understand the 2nd amendment. and are in need of this information.

the laws in calf must be just in someone elses favor, thats sad to see this and to hear about it

i would say yes

sounds like the hammer is not letting the bolt operate freely. try this... take off the dust cover, cock the bolt,pull all the way back if it hangs up the hammer needs filed down at an angle where the bolt can ride foward again. now with the cover off and bolt all the way pulled back and...

cleaning parts try cleaning it in boiling water first with some baking soda.... i did this on a blueing job for my ak receiver i then used a cold blue to boot. and it came out great i just put it in the hot soda/water for about a minute or two, when pull it out the part will be hot...

i use an old portable dishwasher wood top it looks like a large cutting board. its the perfect size. and very strong. and is laminated partical board got a press mounted off center so i have more room,scale,lube pad, trimmer. you know... for stubborn case resizing, you put one hand towards the...

got any 6.5x55 brass (used) not new. i have some other cal. brass to trade.or purchase 38 spec., 30-06 milsurp., 9mm,, some 308, and some 223rem i have to count it.. also have some but not a lot of 40 and 45acp. i hope this is the right place to make a request. i just picked up a swede m38 and...