Search results for query: *

  1. M

    Reusing pulled powder

    This would never be a question if components werent so hard to come by.
  2. M

    Reusing pulled powder

    I have a single shot rifle that does not like the hard primers of factory steel cased ammo. I might get 3 misfires out of five shots. I have brass, primers, and powder but, I am low on projectiles.
  3. M

    Need a new bullet puller (collet type)

    I use the RCBS and have no complaints.
  4. M

    Reusing pulled powder

    I think its better just to use it as fertilizer. Thanks for the replies.
  5. M

    Reusing pulled powder

    Hey all. I pulled a bunch of herters 7.62x39 bullets to reload in brass. I kept the powder and I was wondering if it would be a good idea to reload it or dump it. I have no idea what kind of powder it is or how many grains were used. Whats the general feeling about using unknown powder?
  6. M

    Frankford digital scale

    Mine was very accurate. I compared it to my little precision scale, and it was always spot on. Thanks for the link Mad!! I just ordered it.
  7. M

    Frankford digital scale

    I had mine for almost a year. Loved that scale. I dropped it a few days ago and now it reads all whacky. I will get one again.
  8. M

    Lee Perfect Powder Measure: precise enough for light loads?

    The original ppm meters 2.9g of 700x very well for me. I would say yes to your question.
  9. M

    Where are reloading components available (Not a Discussion Thread)

    2011Redrider, Thank you, thank you for that one!!!
  10. M

    Looking for a CFE Pistol load for 124gr 9mm

    I got good results(accuracy) with 4.6gr with plated 124gr bullets @ 1.10 oal. I got better results with 4.8gr, same bullet and oal. Everything ran fine with the 4.6, but I feel it was a bit on the light side. I feel that 4.8 - 5.0 would be near perfect for plated 124gr loads.
  11. M

    Tumbling plated bullets?

    Well, I tried a small batch. It was a complete waste of time. Just like rc said. It took a long time cleaning out the cavity. Goop still on them. A mineral spirit bath is in order. Thanks guys!!
  12. M

    Tumbling plated bullets?

    Hey guys, I have a bunch of pulled gold dots that have some sort of sticky black stuff on them. Would it be okay to tumble these in walnut media?
  13. M

    Indian 7.62 ofv

    I have a bunch of this 93 ofv ammo that I plan on reloading without firing it first. So, I pulled quite a few bullets and there is tar on the inside of the neck. The brass looks like its in great shape. My fear is if I dont clean the tar off it will gum the resizing die, and gum up the rifle...
Back
Top