Search results for query: *

I just re-sprung a new 1911 that had the same issue. An 18# hammer spring worked very nicely. Your mileage may vary. Lafite

I will be happy to test them for you, Will let you know if any of them didnt work. Lafitte

Looks like you need to ask Pop if he has some more parts for that press. Take a look at the Lee web site, they have a lot of information about their pressed and operation of them. Lafitte

I don't load 230 much above 800 fps and really here we don't consider 85 to 90 degrees to be hot, just don't leave your ammo baking in the sun. That being said, just don't go above published loading data and you will be fine. Lafitte

I like Remington primers and use # 1 1/2 PRIMERS for standard .38 sp loads and other small pistol any time that i have them. Never a probem! Lafitte

Think past the reloading bench! What do you want to do AFTER you reload it? Lafitte

Mine do! Just a matter of adjusting the dies for the longer .357 mag cases. Lafitte

My experience with them hasnt gone that well. Lafitte

Should be really good for turning money into noise. Lafitte

Sounds like the irons need some adjustment and you can expect the optics that you install will aslo need a bit of tweeking. Lafitte

Never have tried to gage empty cases, just finished ammo. Lafitte

Beveling the edge of the case leaves a sharp edge on the case mouth. Since auto pistols head space on the front edge of the case I like a good flat edge on the case. If anything, I just lightly de-burr the inside of the case. Lafitte

Probably not. Lafitte

4 rounds ? Good grief, shoot 'em, if they don't work just get out the sledge-o-matic and whack away. Lafitte

It is my opinion that full length guede rods for 1911,s are made to sell. I know of no other purpose. Lafitte

The first cartridge that I reloaded was 243 Winchester. In 1963 I purchased a Remington 700 .243 W, along with a 4X Redfield scope and mounts and a box of ammo. As I remember the total price was $134. Lafitte

I am going to check my inventory and make up an order. Am running low but just havent takken the time to order. Merry Christmas to All! Lafitte

The bullets were probably not all cast from the same melt. Lafitte

That works for me. If I have any issue with dirty primer pockets I clea them with a primer pocket brush. Lafitte

I have one that I have used for years, good press, hard to beat. I use it to load .30/06, 45-70, 7mm Rem Mag and others. Lafitte