My mini has a very loose chamber, causing brass to stretch as much as .012", resulting in occasional pieces of brass to separate at the midway point. I was full length sizing with the die adjusted so the press cams over. Consider buying a case gauge and setting up your die so that you're only...
So sorry to hear this. Best wishes to RC's family and friends. I will miss his spot-on reloading advice given in his no BS manner. He has my utmost respect.
Even if the 2nd amendment was "vague and open to interpretation", consider this argument: The Bill of Rights aside, what in the text of the Constitution authorizes the federal government to regulate the possession of arms? An anti-rights zealot will probably reply with some perverted...
My fired brass was .009" over the maximum on the gauge. Now I'm wondering if I need to have the chamber size checked by a gunsmith. I don't want this to be a problem with the next batch I reload. I definitely don't plan on saving the brass from this current batch. I'm not even sure if I will...
My Wilson case gauge finally came in today. All of the re-sized brass I measured was in the acceptable range on the gauge. After comparing this to brass that hasn't been re-sized, I found that I had been pushing the shoulder back .013". I also used a paper clip to inspect my brass for...
I have a Wilson case gauge coming from Midway so I can check the headspace. I can't feel any rut in the brass near the break. I'm working on posting some pics (I'm computer illiterate).
Last weekend I was shooting some .223 I loaded about a year ago. This was the first batch of ammo I had ever reloaded . On the 17th round fired I had a little incident. The case broke in half with the back half clearing the rifle and front half getting wedged between the chamber and the next...
Evening all. I am loading 380 auto for the first time and have a question concerning O.A.L. My components are as follows.
Once fired brass, mixed headstamp.
CCI 500 primers.
Extreme plated bullet, 100 grain RNFP.
Unique or 700x powder.
Bersa Thunder 380
I have not found any load data...
I had the same problem when I received a 20 year old, never used but badly rusted RCBS 4x4 press. I used a solution of Barkeeper's Friend (oxalic acid) and water. Soak the parts for a couple hours and scrub with steel wool. Repeat if necessary. The acid solution did a really nice job of...
A friend recently gave me a box of Speer 100 grain Plinker bullets in 30 caliber. I want to load a few of these up for my .308 Winchester but have not been able to find any load data online. I have an old Speer manual that is too outdated to be considered reliable. I don't normally buy Speer...
I am just getting into loading .45 acp and have a few questions. My components are as follows.
Once fired brass, mostly Federal and PMC headstamp.
Berry's 230 grain plated RN.
Remington 2 1/2 primers for the large primered PMC brass and CCI 500 primers for the small primered Federal...
Thanks for the quick replies. As I am new to reloading, I haven't begun to factor in jump/jam from the lands. I'm not even sure how to measure that. But I think you're both right about backing off my load. I'm not so set on 2700fps that I'll do it at the cost of safety. I know pressure...
Hello, I'm fairly new to reloading and am wondering if anyone has any experience with a .308 Winchester load I am working on for an upcoming cow elk hunt. My load data is as follows.
Lapua brass- never fired- full length sized
CCI 200 primers
44.0 grains Varget
165 grain Nosler Accubond...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.