Search results for query: *

Also when I scrape my finger nail across the cover some black material come off on my finer nail.

So I got a brand new ak and started to clean it real well, when I got done using CLP on the dust cover I noticed some small little black flakes, there was only a few. Is this common? Should I ask them for a new cover?

It’s brand new so haven’t shot it yet

New to aks just got mine. My question is when I pull the charging handle back Slowly it won’t go forward it just stops a bit. But if I pull it harder and let it go it goes into battery. Is this normal with aks?

What’s better ear plugs or ear muffs for indoor shooting?

I’ve been currently storing my rifle in a soft case and my handgun in a hard case.

Other than a safe

What’s the best way to store my rifles and handguns besides a safe. I live in the Midwest humidity has been high.

Thanks for all the input guys, I’m going to go with the psa ak in OD Green.

Anyone that has one of these aks psa are they any good? Pros cons? I’m debating on wether it would be a good first ak.

Yes aluminum

So this photo with the wear around the hole isn’t a concern I am just worried that doing this has shortened the life of the lower.

Is it bad to loosen up the takedown pins by pushing them in and out, ive done it quite a lot. Brand new build.

What size set would I need I’m looking at the kns brand.

So i recently finished my build and noticed on one side where the pin goes in for the hammer the hole looks a bit deformed more so the outside edge of it. I did use a punch to finish the pin maybe I hit the frame not sure. Is this something to be concerned about?

Is it ok to lubricate the safety selector switch, I put a generous amount of lube on the selector switch maybe even too much.

Can I use birchwood Casey’s aluminum black on my ar lower it is Type 3 Hard Anodized, Black. Have a few tiny scratches.

Well good news it came right out. Now does anyone know what size Allen key this set screw uses? Standard?

Well I went ahead and applied a generous amount of jb weld. Will wait and see in 24hrs how it turns out.