Been a little while since I posted but I recently shot a ladder of 338wm 210gr Barnes TTSX over some IMR4350 and found a load I like and will be taking to Africa in June. Made some more practice rounds today and will be using some new brass for the ammunition going to Africa over the next couple...
The girlfriend watched me load some 338WM for a ladder a couple months ago. While watching me meticulously measure the powder she decided she wanted me to be able to do it quicker since I leave for Africa and have limited time to develop the load in the spring when I can get into the range. I...
It will be a bit before I need any after my purchase of SPP from TargetSports… but it is scary to think I have stuff for under $20/k still left. I ideally would like to see them for under $55/k total. The ones marked over $100/k I can tell you I definitely did not pay that either. I believe I...
IMR 4320
375 H&H 300gr
375 H&H 350gr
338 WM 200-210gr
I just have a few pounds of IMR 4320 floating around and could not find a lot of data. I did find some but I try to have more than 1 or 2 sources of information to get a better idea of a median charge and average max.
Thanks for the input. I did do just that I was just looking for a few more sources to broaden the ranges and the "oldest" manual I have is the Lyman 47th along with Sierra's from that time period. I have 9 manuals and with IMR 4320 being discontinued I was open to find some more loads to use for...
I have a few pounds of IMR4320. I would be looking for info from manuals pre-Lyman 47th era. I am looking for loads for the following bullet/calibers:
375 H&H 300gr Solid/Partition
375 H&H 350gr TSX
338WM 200gr SP
338WM 210gr TSX
7mm-08 139gr/140gr
7mm-08 150gr TSX/Partiton
Thanks in advance.
Hmmm..... Seems a lot of people are stressed out and either grumpy or taking everything so seriously.... with that said I have a bunch of "?" fired 38 spl. WW/Win Nickel cases to off load. I have not gone to get a flat rate box yet to see what size I would need for it so it is a decent...
I had been working on the Sako 7mm-08 and found that it liked 40.8gr. of IMR4064 under a Hornady 139gr. Interlock flat base. After being in the rain durning my hunting vacation I decided to pull the stock, do a thorough cleaning and oiling when I discovered that the action was not bedded in the...
I tried to find a happy medium in how I choose to stock components, some decisions were cost based and some is for what works well enough for the intended application. For all my pistol loads I use Unique. I was able to get stocked up decently before the disappearance of it. For my rifles it is...
Got new scent blocker gear as it was time to replace my old gear due to wear and I might be a little fatter. I have to make it to the range to do a final load test today. I will do a final sight in on Wednesday and be ready for opening day.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.