Yes I did measure it , it only set back with my Springfield 1911 about. 003” to 005” and no set back with my CZ sp01. I took a federal factory round I tested it and found it set back even more
With my 1911 , it about .01” and still no set back with CZ. So think it’s more on my gun now than my...
Update from today’s range test
I loaded 40 rounds of RMR 124 gr FMJ loaded to 1.12” col and 4.2 and 4.4 Win 241. It function good on my 2 gun but Springfield 1911 have a good group, I think I like it.
I also load 20 rounds of RMR 115 gr FMJ to 1.115 COL with 4.4 win 231 everything function...
Yes you are right I use RMR in- house bullets and the speer online load data base on some suggestion from this forum. I did not notice the different between TMJ and FMJ. Like I said I am a new loader and also a new shooter too so my knowledge about bullet and gun is very limited I decide to...
I email RMR bullet and ask for COL recommendation but they refused to answer, 1.135" COL and 4.2 win 231 is the data from this forum, I have a pistol loading manual but it useless.
I think I will try shorter COL and see it help .
thanks
Yes I am new to reload, This is the first time I load this type of bullet , I got the information base on the Speer website and also for the highroad forum. 1.135” Col and 4.4 to 4.9 win 231 for 115 gr bullet and same Col with 4.0 to 4.5 for 124 gr bullet.
So do you think if I load it shorter...
Thank you all, I just check dimension on 10 of each bullets115 gr it is .3545" and the 124 gr is .355" very consistent.
test load 5 dummy round with less expand and very light crimp and the result come out lot better than yesterday. I load 1 round on magazine and release the slide stopper and...
at work now but I recall that I can't push with my thumb but I can put it with my hand and I am 125 lb guy . I notice that the federal case is slightly thinner than Winchester case that why when I test with Win case I don't have problem. I dit not check the Dim of the RMR bullet I just received...
I started loading 9 mm 124 gr Round nose from RMR bullet today and I'm having issues with setback. I loaded a dummy round and rack it in my 1911 and measure it , it is about .005" shorter each time I tested it . I try to increase the taper crimp to the point when I use the puller to pull it out...
Yes, I am new to reload , I use Win 231
and my 9mn gun is Springfield 1911 A1 target model and CZ -75 sp01 .
before I start buying reload equipment I always thought that everything is in the book but it turn out I was wrong.
I got many good advice from the other post for RMR round nose bullet
Can some one suggest me a reload hand book that have load data at least for the 3 type of bullet I have , RMR round nose 115 gr , RMR round nose 124 gr , and RMR 124 TC.
I bough a Lyman load data for pistol on Amazon $7 and also I have the online version of Lyman 48th edition, they don't have...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.