Search results for query: *

What is a good clean powder to use in a 2.5" barrel 44spl? I have used Bullseye, and a few Hodgdon brands but still get a good amount of unburnt powder. I know the powder does not have as much time to fully burn in the short barrel and I may have to live with it. Does the crimp have a lot to do...

Any opinions on the Taurus 41 mag? I have a Taurus 44 mag, 44 sp and 22 and so far have had no problems with them. All three shoot real well. I am looking into getting the titanium 4". Their 2" model looks real good too.

Thanks I'd like to see a wharehouse like that In NC somewhere. Only one place around Fay for supplies. Slim pickins.

OAL I agree with the revolver statement but I still mic out the length when setting up the dies. Use a case gauge also. With auto loaders this would be critical. I load 45 as well. My thinking with length was that it had something to do with pressures as well as having the proper amout of...

In my Lee manual the min OAL is given and in others it is not. Is the general rule of thumb to keep it close to the max OAL? For bullets like the 125g 357 you pretty much have to get it close to the min OAL to get a good seat and crimp.

I going to Myrtle Beach SC tomorrow. Does anybody know where I can purchase pwdr ect? I normally order through Midway but wanted to avoid the freight. Thanks

CA 2000 Bulldog I picked one up new on Monday and fired 20 rnds of 240g Rainier handloads through it with no problems. It seems to be a good gun. It seems to be accurate as well. The recoil was not bad. I need to use powder other than the 13.5g of IMR231, lots of unburned pwdr. I did notice...