Search results for query: *

Has anyone else noticed this? Bought a Walker today with Pietta-esque deep blue colors. Also noticed it on the Dragoons at the Hamburg, PA Cabelas in December. I like it a lot.

Do all ROA loading levers rattle? My lever doesn't lock up well at the front, where it latches onto the barrel stud. There is a lot of up and down play. If I pinch it tight at that point, with my fingers, the lever no longer rattles when I shake the gun up and down. The lever seems to be about...

I recently ordered one of these. It is essentially a KA-BAR with a wide tang and a full flat grind. The steel is SK-5 carbon. The blade is .188" thick. A guy on youtube tried to baton his Leatherneck through some very hard wood and a nasty knot. The knife didn't survive, but the edge is rather...

Okay, I went and stripped another knife. Yet another KA-BAR. A 1211. I can't stop squirting Jasco Paint Remover at my knives ... And watching that coating fall away like the black veil of sin from a repentant heathen. I think I may have a problem.

Here's my new KA-BAR Mark 1 Navy knife. First thing I did was strip the black coating with Jasco paint stripper. I like it much better now. It locks nicely into my small hand. If you have large hands, you may find that your hand rides on the pommel.

Will a new Uberti 1858 Remington .44 cylinder fit an old Uberti gun from the 70s?

I can't find Treso nipples for Pietta Remingtons anywhere. No one has them in stock. I found these stainless ones at Cabelas but don't know if they are any better than the stock ones. Has anyone here used them...

I handled one of these (not a Navy Arms, but a Pietta/Traditions) at the local Gander Mountain and was impressed by the fit and finish -- better than the Uberti Remingtons I've seen. I'm a little worried about the steel though. I've read that Uberti's cap & ball stainless is about as soft as...

How do you remove the basepin/loading lever on a Rogers & Spencer? I assume you loosen one or both of those big screws in the frame, but how far should you turn them? I'm looking at a used Navy Arms R&S that I assume was made by Euroarms, but am not sure. I'd like to pull the basepin before I...