I have a 7" AR and it has a heavy (way too heavy if you as me) barrel. I was thinking about having it turned down to a standard type barrel to save on weight, I'm guessing it wouldn't hurt anything.
J.B.
I put my 7" RRA upper on my M16-A1 lower and it will not extract all the way, is this because of the rifle buffer and spring? How do I make it run?
J.B.
I have an 1885 Browning in 7 mag. And have been trying several loads, went by a buddy’s place today and tried three loads and then he offered a fourth one to try. 145 grain Speer Grand Slam loaded with 65 grains of IMR 4350. Don’t look for it in the book, they don’t go this high! LOL Just...
I have had it with this press! It will index like it should 10-15 times and then start short stroking. I replaced the nylon ratchet piece and it didn't help one bit, adjusted the adjustment screw, cussed it a while, took it all apart and tried it all again............. no luck so I cussed it...
I have a Lee 3 hole auto indexing press that is not indexing right. I looked at the web site and couldn’t find the replacement parts. Anybody know where I could find some? I know, I know…………. Jack it up high enough to get a Dillon under it right!! LOL I have two Dillons and never have any...
My 7 year old son has a Handi Rifle in .357 magnum and I want to cut the barrel down to 16-1/2” to make it easier for him to handle. My smith wants around $100 to cut and crown it so I decided to hold off. If I knew what to order I would do it myself, any experts on cutting one by hand?
J.B.
I need a .380 mold, 80-90 grain but I haven't found anything I like. .356" is what I need right? I saw one 90 grain mold on Midways site but I don't want to spend that much.
J.B.
I see a LOT of for sale post that say "no shipping to Cal." Is it that much of a hassel? I know there are guns that they do not allow because they are too EVIL, any info?
J.B.
Wouldn't a firing spring like the ones on a 1911 make an AR15 safer? I've seen a few around the web lately that seem to have fired out of battery(for some reason or another). I know there are lite weight pins around but a spring would keep the pin away from the primer until it was hit by the...
I want to build a SBR and would like to build a 7.5" if I could get one that was reliable. What do I need, a special buffer and/or spring? One other thing, can it be registered to wear a 7.5" and a 10-1/2" barrel? It'd suck to spend the time and money building a 7.5" gun that would not run right...
What do I need to put a bisley frame on my 4-5/8" Blackhawk? I am looking at the stainless factory Ruger frame Midway has and factory grips, I have already put the bisley hammer and trigger in, any thing else I need?
J.B.
I just got a Leupold scope that is marked M8-4x Compact, this isn't a rimfire scope is it? I looked around the Leupold site but didn't see this same scope.
J.B.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.