I haven't seen a new ppk in any gun shops in a long while anyone know what's going on? Did the recall stop production? I like the new S&W except for the long tang. I wonder if it can be ground down to normal size.
Went to range today and shot a number of different defense rounds out of my 1956 Colt Agent. I shot Fed Nyclads Non +P 125, Rem non +P 110SJHP, Hornday 110 critical defense, wadcutters and 158 swc. The most accurate round tested in this gun was the remington 110 SJHP on the money and very tight...
Has anyone tested this round. I noticed that on Gun Tests they tested all the 38 special non+p 110HPs' and found that the Remington 110SJHP was outstanding. Their results were 1.4 inch groups at 25 yards, expansion at .617 and 15 inches of penetration. I this is true that's outstanding results...
I tested three 45 auto loads in my Kimber 3 inch Ultra CDPII.
I don't want to use +p ammo in my gun, so here is what I tested for standard velocity rounds. Testing was done in soaked newspaper with four layers of cotton tee shirt material.
45 Winchester Silvertip (New Version) 185HP 7 inch...
Tested some standard velocity ammo for expansion and penetration in wet pack. I tested the 38 special and 32 Mag. Guns used were S&W 442 and S&W 432 Mag. I used four layers of cotton over soaked newpaper.
Here are the results:
In order of depth:
38 Special Winchester Silvertip 110 non +P 4...
I just purchased two boxes of Code 53722 speer 38 special non +P gold dot 125 HP's. I own a colt cobra older 1966 model and I do not want to use +P ammo in this gun. I do have some 125 HP nyclads and use those, but I am always looking for something a little better with more penetration. Has...
Had about 250 rounds through it, when I took it out to the range again. Fired about 25 rounds and noticed that the trigger did not want to return. The gun still fired but the trigger was not returning quickly. I stopped shooting the gun. Upon cleaning it noticed that a part where the visable...
Just purchased a new Pt-140 and noticed that the larger recoil spring was installed at the factory with the open end forward. I would think that the closed and flat side would face the front. I noticed that on reassembly that the open end got stuck in the recoil spring hole. Any opinons on this...
I have been looking around for some time for a small pistol. Read all the bad things about the Taurus Millenium series guns. I while back I had one in 9mm for a T&E and the pin kept breaking. If it wasn't for that it was shooting fine. Well I was up at KTP yesterday looking for a small 45. They...
Looks like a nice pistol but I have read that Taurus has had many problems with these guns, ie. frames cracking, pins breaking so on. Does anyone know if Taurus has addressed these problems. I like the new Pt-111 Titaniam pistols may be intereseted in one. I also like the size smaller than a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.