Search results for query: *

I have one of the .32acp cylinders and it fit perfectly with no fitting required. As far as firing the .32 S+W/ H&Rmag from the original cylinder goes, it fires great, accuracy is fine, but my original cylinder has a very rough inside surface, and the cases bulge enough that I have to drive...

.22LR is what is known as a "heeled" bullet. if you look closely, you will see that the outer diameter of the bullet is the same as the outer diameter of the brass casing. The bullet has a smaller diameter "heel" that fits inside the case. In contrast. 22Mag is a standard design where the outer...

Option 3 I voted NO in the poll, but thats not quite right. Remington 870 Full Magazine Action open, with one round on the carrier. All I would have to do in an emergency is pick it up and close the action, plus it gives me 4+1 with a bit less danger than having the shell actually...

When I bought my CZ75 I got a $50 discount because it was the display-case one and had gotten a bit scratched up.

For just plinking/ having fun 15-20 grains by Volume of FFFg should be perfect. Do be sure to get the ball seated down on the powder especially with smaller charges.

Found this on CNN: http://www.cnn.com/video/#/video/us/2007/11/15/kirk.6yo.deer.slayer.klrt

I prime my Magtech shells using a standard Lee LoadAll II press. Just push the primer in by hand enough that it will stay in by itself, and then place it on the priming station and work the lever. The only trick is to doublecheck that the primer is seated deep enough. If the shell wobbles about...

I reload 45 colt using 165gr, 200/205gr and 250gr cast bullets. I use 5.0gr of Clays for all three loadings, and it does quite well. It doesn't fill the case, but it works fine, and a double charge would be very obvious. It is a little dirty, but I can live with that. I have also loaded 45...

From CNN: http://news.bbc.co.uk/2/hi/americas/6246800.stm I really hope this is a stock photo :what: :what: