Both guns I have are .45acp. 1st time to use this, I aint sure but I think it's burn rate is about the same as Unique & Win231. Any good load recipes out there. I will be shooting paper at 7-25yrds with a S&W 325PD. 2 1/2" 26ozs. Recoil IS a factor. I will want to use it on my Kimber 5" Auto...
unique powder on a .45acp reload
for the 230 grain .45acp and unique. Use 5.3-5.4 grains. Gives you 813fps with a power factor of 187. it's a good heavy RN or semi-wad cutter load. Also, make sure your brass is tumbled and clean. (Helps cut down maintence on your Lee reloader and gun).
:confused: Was thinking of getting the new 325pd because I load .45acp for my 2 automatics. BUT have heard of problems of unloading hangups and (something I'm not familiar with,moon clips). I was pricing a pre-owned "Good" condition online for $575. Any input on this?? I'm a little leary of...
Got an M-40 2yrs ago. It feed everything I gave it. Reloads, storebought, EXCEPT the 180grn semi-waddcutter. These I had load problems with. I think the config of the bigger wadcutter got hung up on the top feed. The 180 R.N. or smaller grain wadcutter bullets worked great
P.S. You have to put...
A 500 mag will go through a Buick laughing all the way. Forget about a second shot unless your ambidexterous. If you hit your perp it would be like killing a fly with a sledge. Overkill?? :neener:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.